Weigh-In-Motion Strip Sensors

Click image to enlarge
Price Each: Call for Price
  • Strain Gauge Load Cell Sensors in a Minimally Invasive Enclosure for Quick Installation
  • Weigh Vehicles at Speeds up to 80 mph (130 km/h)
  • Designed to Comply with COST 323 & ASTM E1318-09
  • Used in Screening, Enforcement, Data Collection, Tolling & Ports WIM Applications
  • Use to Address SOLAS Verified Gross Mass Container Requirements
Intercomp’s strain gauge based Strip Sensors are a unique alternative to traditional sensor based technology yet a more accurate and longer lasting alternative for ASTM E1318-09 Type I, Type II, Type III and COST 323 A(5), B+(7) or B(10) requirements for High Volume Data Collection and Screening for Direct Enforcement.  Installed within grooves less than 3" (75 mm) in the pavement, the strip load cell delivers lower cost because of the minimal time & labor associated with installation and maintenance.

Contact us for more information!

Weigh-In-Motion Strip
Sensor Application Guide
Weigh-In-Motion Gate Systems
Strip Sensors: Border Crossing
Tolling & Screening
Dynamic Weighbridge
Technology at the Gate
Strip Sensors:
Efficient Pre-Selection
Strip Sensors:
Pre-Selection, Oregon
Strips Sensors:
Data Collection, Washington
Strips Sensors:
WIM Site COST 323
Strips Sensors: Overweight
Identification on Toll Roads
Strip Sensors: Oregon
Green Light Program
Contact Us Technical Support, Calibration & Repair Additional Resources